← 返回
变速驱动中模块化多电平变换器平均电容电压的最优选择
Optimal Selection of the Average Capacitor Voltage for Variable-Speed Drives With Modular Multilevel Converters
| 作者 | Antonios Antonopoulos · Lennart Angquist · Lennart Harnefors · Hans-Peter Nee |
| 期刊 | IEEE Transactions on Power Electronics |
| 出版日期 | 2015年1月 |
| 技术分类 | 拓扑与电路 |
| 技术标签 | 多电平 PWM控制 功率模块 |
| 相关度评分 | ★★★ 3.0 / 5.0 |
| 关键词 | 模块化多电平变换器 M2C 变速驱动 电容电压纹波 子模块电容 电机驱动 |
语言:
中文摘要
本文研究了基于模块化多电平变换器(M2C)的电机驱动系统。在低于基准转速运行时,系统对电压要求降低,因此可降低子模块电容电压,以容纳更大的电压纹波,同时确保不超过电容峰值电压限制。该方法优化了变换器在变速工况下的运行效率与性能。
English Abstract
Variable-speed drives have reduced voltage requirements when operating below the base speed. In a modular-multilevel-converter-based (M2C-based) motor drive, it is then possible to operate with reduced voltage in the submodule capacitors, than at the base speed. In this sense, a greater capacitor-voltage ripple can be accommodated, without exceeding the maximum peak-capacitor voltage. This paper p...
S
SunView 深度解读
该研究涉及的模块化多电平(M2C)拓扑是高压大功率变换器的核心技术。对于阳光电源而言,虽然目前光伏和储能产品(如PowerTitan系列)主要采用组串式或集中式拓扑,但M2C技术在超高压直流输电及大型工业电机驱动领域具有潜力。该论文提出的电容电压动态优化策略,可为阳光电源未来研发更高功率密度、更宽运行范围的工业变频器或大型储能PCS提供拓扑优化思路,有助于提升系统在部分负载下的效率表现。